User Preset; System Status - NEO WI NODE Manual De Usuario

Single means this port will only output one
universal.
LTP means this port will output the latter one be-
tween the universal of principle and secondly. The
unit will compare the two universal and resend the
later one to the network.
HTP means the port will output the one with higher
value between the universal of principle and sec-
ondly. The unit will compare the two universal and
resend the higher data to the network. They can be
set within the range of 0.0-F.F./001-255. (These two
formats can be change through Display Mode).
• 1-2 DMX port disabled
Any of the port 1-2 can be set as Disabled status.
Upon the port has been set as Disabled status, the
DMX port will be disabled, it cannot send or receive
any data from now on.
Please note that the Framerte/fs only available
for Output status; The Secondly and Resend op-
tion only available for the HTP/LTP mode under
the status of Output.
P. 8
Neo Wi NODE -
English version
Set ID NO.
Enter into the main menu by press MENU button,
pressing UP and DOWN to choose the Set ID NO.
option, then press the ENTER to confirm your se-
lection. You can set the ID No. for the unit from 000
to 255. The ID is only used to recognize each of the
unit easily.

User Preset

Enter into the main menu by press MENU button,
then pressing the UP and DOWN to choose the User
Preset option and then press the ENTER to confirm
your selection. This setting help you easily use the
application avoid complicated setup procedure.
You can simply choose you desired mode by press-
ing UP and DOWN, and confirm your choose by
pressing ENTER.
Version
You can check the version number from this option.

System Status

You can check if fixture hardware work normally or
not.
Web page settings
Input IP of wifi node in web browser to access
internal webpage of this fixture. Default account is
admin, Password is admin.
Please set the webpage as below image. Please set
the dmx ports refer to above menu instructions
(Set DMX port). See next page.