OZ Lifting Products COMPOZITE OZ1200DAV Manual Del Operador página 13

Inspection Chart
NOTE: Disassemble crane including ratchet jack, boom, and winch periodically to inspect each for damage.
Use the following chart to determine what type of inspection is necessary. Frequent Inspection (F) and
Periodic Inspection (P).
Location
Crane
Foundation
Fasteners
(including moutning fasteners)
Handle
NOTE: Please refer to the winch owner's manual for the winch inspection chart.
Repairs
All repairs must have factory authorization. Contact OZ Lifting Products LLC
two-year limited warranty and potential damage.
Perform recommended inspections to identify which parts should be replaced. Only use OZ Lifting Products
®
LLC replacement parts. To order replacement parts, contact your local OZ Lifting Products LLC
Please have the serial number, part number and a description available when calling.
Load Rating
Check For
Damage, cracks, rust, chipping, dents excess wear, or corrosion.
Unusual sounds
Smooth load movements
Equipment properly lubricated
Signs of overloading (cracks, dents, or damage)
Proper function when operated with a load equal to the load rating
Good condition/supports the crane under all conditions
Level, no swerving of boom
Cracks, corrosion, damage (check by removing crane base from foundation)
Firmly installed
Properly tightened
Stripped threads, bent, or damage (check by removing crane from foundation)
Rotates freely in both directions
*Table based on 1/4 inch wire rope. 3/16" cable will be lower.
Load Ratings (lbs.) 1st. Layer
Boom Position 1 1200 lbs.
Boom Position 2 900 lbs.
Boom Position 3 700 lbs.
Boom Position 4 400 lbs.
EN pg.13
®
to prevent voiding of the
Mid Drum Full Drum
875 lbs. 550 lbs.
875 lbs. 550 lbs.
700 lbs. 550 lbs.
400 lbs. 400 lbs.
F P
X
X
X
X
X
X
X
X
X
X
X
X
X
®
dealer.