Troubleshooting; Disposal Of The Appliance - 1 BY ONE VINTAGE TURNTABLE Manual De Instrucciones

EN
TROUBLE SHOOTING
If you have followed the instructions and are having difficulty when operating the
DE
turntable, please locate the PROBLEM in the left column below. Check the corre-
FR
sponding POSSIBLE CAUSE AND SOLUTION column to locate and fix the problem.
ES
IT
PROBLEM POSSIBLE CAUSE AND SOLUTION
Ensure that the turntable is powered on
Check the master volume is not turned to minimum
No power
Remove the power adapter/connection cable and
reconnect again after 2 minutes.
Ensure the turntable is on the correct source.
The protective needle cover was not removed. Remove
No sound on it first.
The tie-wrap was not removed from underneath the
phono source
tone arm. Remove it first.
Tone arm LOCKING CLAMP was not released. Release it
first.
The stylus is dirty. Remove dust on the stylus with a
Poor sound on
stylus-cleaning brush.
phono source
Dust or dirt has collected on the record. Clean the
record with a high-quality record cleaner.
Ensure the turntable is on correct source.
Check that the turntable is powered on.
No sound on
Check the volume level on the external device.
audio out
Check the correct source is selected on the
external device.
Remove the audio cable and reconnect again.
08
SPECIFICATIONS
SPECIFICATIONS
AC adapter
Record speed
Power output at Phono
Power output at USB
Specifications and functions connected to the continual improvement of the device
are subject to change without notice.
DISPOSAL

Disposal of the appliance

Under no circumstances should you dispose of the appliance in
normal domestic waste. This product is subject to the provisions of
European Directive 2012/19/EU.
Dispose of the appliance via an approved disposal company or your municipal waste
facility. Please observe currently applicable regulations. Please contact your waste
disposal center if you need any further information.
The appliance's packaging is made from environmentally friendly
material and can be disposed of at your local recycling plant.
AC Input = 100-240V 50/60Hz
DC Output = 9V 600mA
33, 45, 78 RPM
0.3W x2 RMS power output
1.8W x2 RMS power output
09
EN
DE
FR
ES
IT