Kreg KHI-PULL-INT Manual Del Propietário página 4

3
For Knobs: Insert one Drill Guide in the
centre hole and thread on a Knurled Nut from
the bottom of the Base.
Adjust the Edge Guide to the desired
distance from the edge of the workpiece on
which you wish to mount the pull or knob. For
dimensions in inches, align the arrows at the
ends of the Edge Guide with the appropriate
dimension on the inch scales along the edges
of the Base. For dimensions in millimetres,
align the back edge of the Edge Guide with
the appropriate dimension on the millimetre
scales along the inside edges of the Edge
Guide adjustment slots. Tighten the T-Knobs.
ATTENTION The Edge Guide adjusts to centre
the Drill Guide(s) from 1" to 5" [25mm to 120mm
on the metric scale] from the edge of the
workpiece.
Assembly
Inch scale
Millimetre scale