Kreg KMA2685-INT Manual Del Propietário página 3

ATTENTION Use the Kreg Drawer Slide Jig in conjunction with the drawer-slide manufacturer's instructions.
To install drawer slides in face-frame cabinets, slide-mounting rails must be attached to the inside faces of the
cabinet sides to provide a drawer-slide mounting surface that is flush with the inside edges of the face-frame
stiles. Drawer boxes must be mounted before the false-fronts are attached. The Drawer Slide Jig cannot be
used to mount a drawer at the bottom of a cabinet. To mount a drawer at the bottom of a cabinet, see the section
INSTALLING A DRAWER AT THE BOTTOM OF A CABINET.
ATTENTION If installation instructions supplied with your drawer slides are vague, incomplete or nonexistent,
please contact the manufacturer or hardware supplier for complete installation information. Major hardware
manufacturers have this information on their Web sites.
MOUNTING DRAWER-SLIDE CABINET MEMBERS
¾-Extension and Full-Extension Drawer Slides
Position the Brackets
• Extend the Upper Slider and Lower Slider
on each bracket.
• Position Bracket A on the left side of the
cabinet, Bracket B on the right side, with
both Brackets extending into the cabinet.
• Place the Upper Sliders on the top edge of
the face-frame rail that is under the drawer
opening and the Lower Sliders against the
inside faces of the face-frame stiles.
• Clamp the Brackets to the face frame.
Fasten the Drawer-Slide Cabinet Members
• Place the drawer slides on the brackets.
For overlay drawer fronts, follow the
drawer-slide manufacturer's instructions
for the slide setback distance from the face
of the stile. For inset drawer fronts, add the
thickness of the drawer front.
• Using the vertical mounting slots in the
drawer-slide cabinet members as guides,
drill pilot holes and screw the cabinet
members in place.
• Remove the Brackets from the cabinet.
USING THE JIG
FACE-FRAME CABINETS
2
Sliders extended