Installation Of The Motor - V2 ZARISS Serie Manual Del Usuario

3.3 - INSTALLATION OF THE MOTOR

To install the ZARISS motor, follow the following steps closely:
1. Fix bracket A to the pillar using rawplugs suited to the pillar
material
m
PLEASE NOTE: the bracket should be perfectly
horizontal. Use a spirit level to accurately position the
bracket
2. Position the straight arm C on the motor shaft
3. Tighten screw E, after having inserted the washer P and the
grower Q
PLEASE NOTE: the casing D should be fitted later, after
having fixed the opening mechanical stop
4. Fix the motor reducer onto bracket A using the two screws F
and the relevant nuts and washers
5. Fit the curved arm G onto the straight arm C using the
pivot-pin I and snap-ring L
6. Fit the bracket B onto the curved arm G using the pivot-pin I
and snap-ring L
7. Fix the bracket B onto the gate by welding or using appropriate
screws for the gate-leaf material
PLEASE NOTE: bracket B should be level with the lower
part of bracket A
- 42 -