MX 120V 15A-20A Manual Del Usuario página 4

INSTALLATION
To protect your office equipment from power surges, voltages dips, sustained
over-voltages, blackouts and electromagnetic and radio frequency interferences,
all cables (power & data) leading into or out of your equipment must be connected
to your MXPOWER surge protector.
IMPORTANT
Power surges and spikes can pass through your system
from any AC power outlet, phone line, grounding wire or network
cable that is connected to your office equipment.
1
VERIFY PRODUCT
Inspect the product to ensure that it is free from any visible damage.
If product shows any fault, please contact Customer Service
at 1.888.422.6726 or oesales @ memoryexpertsinc.com.
2
SHUT DOWN EQUIPMENT
Turn off the power to all equipment you wish to protect and unplug
all power cables from wall outlets.
3
CONNECT SURGE PROTECTOR
Plug the surge protector into a properly grounded AC outlet.
4
CONNECT TEL / FAX LINE (if applicable)
A
Plug one end of the phone cable into the wall's
telephone jack and the other end into the ''IN'' TEL / FAX
outlet on the surge protector.
B Plug one end of your second phone cord into the office
equipment and the other end into the ''OUT'' TEL / FAX
outlet on the surge protector.
5
CONNECT ETHERNET LINE (if applicable)
A
Plug one end of the Cat5e network cable into the
wall and the other end into the ''IN'' ETHERNET
outlet on the surge protector.
B Plug one end of your second network cable into the office
equipment and the other end into the ''OUT'' ETHERNET
outlet on the surge protector.
If the ''Ground OK'' light is displayed, the outlet
is properly wired and grounded.
If the "Ground OK" light is blinking, the outlet
is not grounded. Call an electrician to correct
the wiring in the building or outlet.