Installation - THERMEx SLIM S4 PLUS Instrucciones De Montaje

M 520423368227072016

INSTALLATION

Slim S4 Plus is supplied with an internal motor and the range hood can either vent exhaust out into the open air or re-circulate the air. The hood must
be installed in a wall cabinet without a base.
Follow the steps that match the type of hood you have chosen.
INSTALLATION OF THE NON-RETURN VALVE
Before installing the hood, the non-return valve must be mounted onto the hood:
INSTALLATION OF THE HOOD
The hood is installed in the cabinet using the following steps:
1
Mount the brackets onto the side of the hood.
4
Mount the spacer on the hood.
2
Measure and cut a hole for the vent.
5
x4
x4
Screw the hood to the cabinet's sides.
THERMEX SLIM S4 PLUS
Place the non-return valve on the flange on the motor.
3
Push the hood up into the cabinet.
6
Push the spacer into the wall so that the hole
between the hood and the wall is sealed.
37