TRAPP WM-350 Manual De Instrucciones página 34

12
1
13
3
Assemble as shown in the pictures:
Start by attaching the 3 rear clamps (Fig 1)
 
and so on for both sides.
For proper operation of the WM-350 lawn
 
mower, use the grass catcher.
1 1
1
1
34
Fixing the Handle to the Base
10
11
14
9
7
1
2
3
4
Assembly of Grass Catcher
2 2
2
2
To fix the handle to the base, do as follows:
Place the hole cap (14) in the edge of lower
 
right cable (1) and lower left cable (1).
6
Place the bottom right cable (1) and left
 
(1) in base housing (3). Make sure the hole
(2) of the lower handle coincides with the
hole (4) of the base and fix it using the
screw (5).
8 Carry out the same procedure for the
 
lower right handle.
Get the upper handle (6), place the screw (7)
 
and tighten it with the butterfly nut (8 and 9).
After handles (1 and 6) are assembled,
 
fix the handle support (10) using the
screw (11) and the
nut (12). To fix the
power supply cord
to the lower handle
5
(1), use the clamp
(13).
www.trapp.com.br
3 3
3
3
4 4
4
4