WATER COOLER CONNECTION
(optional arrangement)
• Locate the compartment for the water co-
oler connection on the back side of the ge-
neator.
• Connect the power cable and the presso-
stat cable to the connector inside the com-
partment.
FOOT PEDAL / REMOTE CONTROL AND
DIGITAL TORCHES CONNECTION
• Connect the foot pedal 12 pin plug (see
connection diagram) to the front panel of the
machine into socket 7.
• To activate the foot pedal select button T1 on
the front panel of the machine. LED L1 lights
on.
• Select the function mode of remote control
on the Basic Setup Menù.
Connection diagram 1
FUNCTIONS AND CONTROLS
FRONT PANEL (FIG. 11)
1
2
5
7
Fig.11
1. Control panel
2. Regulation knob for welding current and
welding parameters
3. Display showing the preset parameters,
voltage or current during welding
4. Negative plug (-): Connect the ground
lead or the electrode holder pincers in
case of MMA welding (depending on the
polarity requested by the electrode, prin-
ted on the packaging) and the torch in
case of TIG welding
5. Positive plug (+): Connect the ground
lead or the electrode holder cable in case
of MMA welding (depending on the pola-
rity requested by the electrode, printed
on the packaging) and the ground lead in
case of TIG welding
6. Attachment for the connection of the torch
gas tube
7. Connector for the torch trigger cable or for
the foot pedal, remote control torches and
digital torches.
REAR PANEL (FIG.12)
A. Generator start/stop (ON/OFF) switch
B. Power cable
C. Connector for the protection gas tube for
TIG arc welding
D. Compartment for the water cooler connec-
tion.
A
B
C
3
6
4
Fig.12
D
EN-9