Coffee Preparation - WMF LINEO Instrucciones De Uso

Note: After a power failure or the mains plug was pulled out, the time must be
re-set.
You can always adjust the set time.
Press the Set button and hold this down for approximately 4 seconds until the time
blinks.
Now set the desired time by pressing the h and min buttons and confirm this by
pressing the Set button.
Setting the automatic switch-on time
The device's switch-on system starts the brewing process automatically at the desired
time. The switch-on time can be set for up to 24 hours in advance.
Briefly press the Set button once. The display will show you Set and . Set the
switch-on time by pressing the h and min buttons and confirm the switch-on time
by pressing the Set button.
As long as you do not confirm the switch-on time by pressing Set, the set switch-on
time will blink. After approximately five seconds, the display switches back to the
time without saving the switch-on time.
Note: After a power failure or the mains plug was pulled out, the switch-on time
must be re-set.
Information about the stainless steel pot
(version with vacuum jug only)
The pot is designed as a serving pot and best keeps coffee warm when filled to the
maximum. The keep-warm time can be drastically reduced if only filled partially or
with residual amounts. It is best if the pot is rinsed with hot water before prepara-
tion.
For technical reasons, the seal made by the drip-through lid is not 100 percent sealed
so that it can still easily be opened after the coffee has cooled down. To close, lightly
tighten the lid. Only use the filled pot in an upright position.
To pour, press the pour button on the handle.
To open the pot, lightly turn the lid in a counter-clockwise direction. Ensure that the
pour button is located over the handle once again after closing the lid.
The double-walled, stainless steel container is absolutely unbreakable. Nevertheless,
it should be protected from mechanical stresses.
Rinse the pot regularly. If iron particles from water set on the stainless steel surface,
it may lead to localised corrosion at that point. Therefore, remove these deposits
immediately with a stainless steel cleanser.

Coffee preparation

You can remove the water tank for easy filling. Open the water tank by pressing on
the lid. Only pour cold water into the tank. The water level display applies to the
fresh water quantity that is needed to brew the desired number of 125 ml cups of
coffee.
Swing out the swing-out filter to fill with ground coffee. Place a 1 x 4 paper filter in
the filter, but fold the edge before doing so. The paper filter should not extend over
the edge of the filter, so it is therefore to be lightly pressed with your hand.
Fill with the required amount of ground coffee. Depending on personal test, figure
approximately 5-7 g medium-fine ground coffee per person. If the coffee is ground
too finely, the filter may overflow.
Close the swing-out filter until you hear an audible click.
12