Operation - Delta GR275 Manual De Instrucciones

OPERATIONAL CONTROLS ANd AdJUSTMENTS
STARTING ANd STOPPING THE GRINdER
Make sure that the switch is in the "OFF" position before plugging the cord in the outlet. do not
touch the metal prongs of the plug when unplugging or plugging the cord.
The on/off switch (A) Fig. 8 is located on the front of the grinder. To turn the machine "ON", move the switch up to the
"ON" position. To turn the machine "OFF", move the switch (A) down to the "OFF" position.
LOCkING THE SWITCH IN THE "OFF" POSITION
IMPORTANT: When the machine is not in use, lock the switch in the "OFF" position to prevent unauthorized use.
To lock the machine, grasp the switch toggle (B) and pull it out of the switch (Fig. 8). With the switch toggle (A) removed,
the switch will not operate. However, should the switch toggle be removed while the grinder is running, the machine can
be turned "OFF," but cannot be restarted without re-inserting the switch toggle (A).
In the event of a power outage (such as a breaker or fuse trip), always move the switch to the
"OFF" position until the main power is restored.
VARIABLE SPEEd CONTROL
The grinder is equipped with a variable speed control knob (A) Fig. 9. When you turn the knob all the way left (counter-
clockwise), the RPM is 2000. The rotation increases as the knob is turned right (clockwise). When you turn the knob all
the way to the right, the RPM is 3450.
A
Fig. 8
FLEXIBLE LAMP
The flexible lamp op er ates in de pen dent ly of the grinder.
To turn the lamp on and off, rotate the switch (A) Fig. 10.
To reduce the risk of fire, use a 40 watt
or less, 120 volt, reflector-track type light bulb (not
supplied). dO NOT USE a stan dard house hold light
bulb. The reflector-track type light bulb should not
extend below the lamp shade.

OPERATION

A
B
A
10
Fig. 9
Fig. 10