WEBLE 19710 Manual De Uso página 12

Mounting the extension kit
Note
This section describes and illustrates how to mount the
4th-bicycle extension kit for hitch rack P32-S. The 3rd-bicycle
extension kit for hitch rack P22-S is mounted in a similar
manner.
11**
10**
* Can be used with 3rd-bicycle extension kit
** Can be used with 4th-bicycle extension kit
1. Remove the wheel rail (20). Do not reuse the screws and nuts.
2. Install the extensions (7) with the wheel rail (20), screws (3)
M6x70, spacer washer (34) and nut (4).
3. 3rd-bicycle extension kit: Tighten the wheel rails (8)
with the screws (5) M6x25 and nuts (6).
4. 4th-bicycle extension kit: Tighten the wheel rails (8)
with the strut (11), screws (5) M6x25 and (9) M6x30,
spacer washers (10) and nuts (6).
9**/5*
3
20
5
8
7
6
34
4
M+P-25A-0148
Mounting the rack frame for the extension
kit for a 4th bicycle
22
21
24
1. Open the quick release clamp (21) on both sides upwards
by approx. 90°
2. Press the quick release clamp (21) against the rack frame (22)
and press out the screws (23) as far as shown from plastic
guide (24).
Note
The screws (23) may be jammed in the hub of the plastic
guide (24). In this case, press the quick release clamp (21)
more forcefully against the rack frame (22).
3. Using the ring spanner AF 8, completely unscrew 8
screws (23).
4. Remove the rack frame (22) from the bicycle rack.
5. Remove the bicycle bracket; see the installation and operating
instructions of the bicycle rack P22-S/P32-S.
6. Place the rack frame (12) of the extension kit on the bicycle
rack.
A
12
21
24
7. Position the quick release clamp (21) on both sides in the
transport position on the rack frame (12) and screw in the
screws (23) far enough that the distance between the rack
frame (12) and plastic guide (24) is 9 mm (A).
- 10 -
22
23
21
12
23
21
M+P-25A-0153
M+P-25A-0154