Disposal And Recycling - EINHELL Expert TE-PL 82 Manual De Instrucciones

Anleitung_TE_PL_82_SPK8__ 19.10.12 11:42 Seite 26
GB
8.4 Replacing the drive belt (Fig. 17-18)
The belt should be replaced by a trained expert.
n
The drive belt (b) must be replaced if it is worn.
n
Undo the screws (a) and remove belt cover at
n
the sides (6).
Remove the worn belt drive (b) and clean the two
n
belt pulleys (c/d).
Place the new drive belt on the small belt pulley
n
(c) and pull the belt onto the large belt pulley (d)
whilst turning the planing shaft.
Ensure that the longitudinal grooves on the drive
n
belt are in the guide grooves on the drive wheels.
Fit the belt cover (6) and secure it with the
n
screws (a).
8.5 Maintenance
There are no parts inside the equipment which
require additional maintenance.

9. Disposal and recycling

The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.
26