Operation; Keeping Area Clean; Sawdust Port; Saw Assembly Lock Knob - Skil 3601 Instrucciones De Funcionamiento Y Seguridad

SM 2610029990 06-13_3601 6/21/13 12:16 PM Page 16

Keeping Area clean

Sawdust and wood chips that fall under the saw will
accumulate on the floor. Make it a practice to pick up and
discard this dust when you have completed cutting.
See figure 10.
The sawdust port is located at the rear of the upper guard.
A dust collection system or dust bag can be attached to this
port to aid in the removal of sawdust from the work area.
The sawdust port accepts a standard 1-1/4" vacuum hose.
Saw Assembly lock
See figure 11.
To reduce the risk of injury, make sure
W RNING
the switch is OFF before locking saw into
ripping operation.
The saw assembly lock is used to lock the saw in place
while performing rip cuts.
To engage and lock saw assembly: pull saw assembly
lock knob, rotate 90 degrees so shaft pin is aligned with the
deep slot, then release knob. Slide saw to center of rail until
lock engages.
To disengage and unlock saw assembly: pull saw
assembly lock knob, rotate 90 degrees so shaft pin is
aligned with the shallow slot, then release knob.
See Figure 11.
The Switch has a removable lockout switch key to protect
against unauthorized use.
1. To turn the tool ON, insert the lockout switch key into the
switch housing. As a safety feature, the switch cannot be
turned ON without the lockout switch key.
2. Flip the switch upward to the ON position.
3. To turn the tool OFF, move the switch to the down
position.
4. To lock the switch in the OFF position, remove the
Lockout switch key from the switch. Store the key in a
safe place.

Sawdust port

Switch

operation

FIG. 10
FIG. 11
Saw Assembly
lock
(engaged)
lock Slot
Unlock
Slot
16.
Dust port
Dust Bag
Dust
collection
System
lock-out
Switch Key
(removable)
Switch