Technical Data - Protool IDC 15-2 TEC Manual De Instrucciones

Technical data

Battery-powered hammer screwdriver
Motor voltage
Idling speed*
Speed under load
Impact rate
Torque – screwing into soft/hard material
Torque
Spindle
Max. drill diameter
Screws in spruce
Weight without battery
Accessories
Charger
Mains voltage (input)
Mains frequency
Charging voltage (output)
Rapid charging
Conservation charging current, pulsating
Charging times for:
LiIon 2.6 Ah
NiCd 1.3 Ah
NiMH 2.0 Ah
Permitted charging temperature range
Temperature monitoring
IDC 15-2 TEC battery packs
Voltage
Capacity
Weight
IWC 18-2 TEC battery packs
Voltage
Capacity
Weight
* Speed specifi cations with fully charged battery pack.
The specifi ed illustrations are at the beginning of this operating manual.
12
1 gear
st
2 gear
nd
in wood
in metal
max. diameter
80% approx. 45 min.
approx. 25 min.
approx. 50 min.
IDC 15-2 TEC
14.4 V
0 – 400/min
0 – 2000/min
1700/min
3400/min
35/55 Nm
200 Nm
½" external square / ¼" internal hexagon
8 mm
1.4 kg
230 – 240 V ~
50/60 Hz
7.2 – 18 V =
max. 3 A
approx. 0.06 A
NiCd 2.4 Ah
NiMH 3.0 Ah
–5 °C to +45 °C
via NTC resistor
BP 15 LiIon
0.625 kg
BP 18 LiIon
0.715 kg
IWC 18-2 TEC
18 V
40/60 Nm
300 Nm
50 mm
12 mm
12 mm
1.5 kg
BC 3
100% approx. 70 min.
approx. 50 min.
approx. 70 min.
14.4 V
2.6 Ah
18 V
2.6 Ah
GB