Additional Safety Warnings - MIRKA AROS-B 150NV Instrucciones De Manejo

WARNING
• Always wear required personal safety protection in accordance with manufacturer's instructions and local/national
standards while using this tool
• Read the Materials Safety Data Sheet (MSDS) for the work surface
• If any physical hand/wrist discomfort is experienced, stop working and seek medical attention Hand, wrist and arm
injury may result from repetitive work, motion and overexposure to vibrations
Safety rules for battery pack and charger
WARNING!
• Important safety and operating instructions for your battery and charger Before using the charger, read all
instructions and warnings on the charger, the battery pack and the tool
• If the battery pack casing is cracked or damaged, do not insert into charger There is a danger of electric shock or
electrocution
• Do not allow any liquid to get inside charger Electric shock may result
• This charger is not intended for any uses other than charging rechargeable batteries
• Do not place any object on top of the charger, near any heat source or place the charger on a soft surface that may
result in excessive internal heat
• Make sure the cord is located so it will not be stepped on, tripped over, or otherwise subjected to damage or stress
• Do not use the charger if it has received a sharp blow, been dropped or otherwise damaged in any way
• DO NOT store or use the tool and battery pack in locations where the temperature may reach or exceed 50 °C
• The charger is designed to operate on standard household electrical power (100–240 VAC) Do not attempt to use it
on any other voltage
CAUTION
• Always ensure the work piece to be sanded is firmly fixed in place
• Before changing the abrasive always disconnect the power source
• Never carry, store or leave the tool unattended with the power source connected )
• Keep hands clear of the spinning pad during use
• Do not allow the tool to free speed without taking precautions to protect any persons or objects from the loss of the
abrasive or backing pad

Additional safety warnings

• Read all instructions before using this tool All operators must be fully trained in the proper, safe use of this tool
• All maintenance must be carried out by trained personnel For service, contact a Mirka authorized service center
• If the tool appears to malfunction, stop using it immediately and arrange for service and repair
Additional information on battery and charger
• Never attempt to open the battery pack for any reason If the plastic housing of the battery pack breaks or cracks,
immediately discontinue use and do not recharge
Mirka® AROS-B 150NV & AOS-B 130NV • 32 mm (1 ¼") • 10.8 V
en
45