Stacked Washer/Gas Dryer Installation Requirements - Maytag Commercial MLG22PDAWW Instrucciones De Instalación

STACKED WASHER/GAS DRYER INSTALLATION
REQUIREMENTS
Stacked Washer/Gas Dryer Location
Selecting the proper location for your washer/dryer improves
performance and minimizes noise and possible washer "walk. "
Your washer/dryer can be installed in a basement, laundry room,
or recessed area. This washer/dryer is not intended for install in
a mobile home or recreational vehicle. See the "Drain System"
section for more information.
Companion appliance location requirements should also
be considered.
IMPORTANT: Do not install or store the washer/dryer where it will
be exposed to the weather. Do not store or operate the washer/dryer
in temperatures at or below 32°F (0°C). Some water can remain
in the washer and can cause damage in low temperatures. Proper
installation is your responsibility.
You will need:
A water heater set to deliver 120°F (49°C) water to the washer.
■
A grounded electrical outlet located within 6 ft. (1.8 m) of
■
where the power cord is attached to the back of the washer.
See the "Electrical Requirements" section.
Hot and cold water faucets located within 4 ft. (1.2 m) of the
■
hot and cold water fill valves, and water pressure of 20–100 psi
(137.9–689.6 kPa).
A level floor with a maximum slope of 1" (25 mm) under entire
■
washer/dryer. Installing the washer/dryer on soft floor surfaces,
such as carpets or surfaces with foam backing,
is not recommended.
A sturdy and solid floor to support the washer/dryer with
■
a total weight (water and load) of 450 lbs (204 kg).
A floor drain under the bulkhead. Prefabricated bulkheads with
■
electrical outlets, water inlet lines, and drain facilities should be
used only where local codes permit.
8
Stacked washer/gas dryer installation clearances:
The location must be large enough to allow the washer
■
and dryer doors to be fully opened.
Additional spacing should be considered for ease of installation
■
and servicing. The doors open more than 180°. The washer
door is not reversible.
Additional clearances might be required for wall, door, and
■
floor moldings.
Additional spacing of 1" (25 mm) on all sides of the washer/
■
dryer is recommended to reduce noise transfer and to improve
spin-up performance of the washer.
Companion appliance spacing should also be considered.
■
When installing a gas dryer:
IMPORTANT: Observe all governing codes and ordinances.
Check code requirements: Some codes limit or do not
■
permit installation of clothes dryers in garages, closets,
or sleeping quarters. Contact your local building inspector.
Make sure that lower edges of the cabinet, plus the back and
■
bottom sides of the washer, are free of obstructions to permit
adequate clearance of air openings for combustion air. See the
"Recessed Area and Closet Installation Instructions" below for
minimum spacing requirements.
Recessed Area Installation Instructions
This washer/dryer may be installed in a recessed area. For recessed
area installations, minimum clearances can be found on the warning
label on the rear of the dryer or in the "Dimensions/Clearances"
section.
The installation spacing is in inches and is the minimum allowable.
Additional spacing should be considered for ease of installation,
servicing, and compliance with local codes and ordinances.
NOTE: The dryer must be exhausted outdoors.