Route Drain Hose; Secure Drain Hose - Maytag Commercial MLE22PD Instrucciones De Instalación

Ocultar thumbs Ver también para MLE22PD:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTALLING STACKED WASHER/DRYER

Route Drain Hose

Proper routing of the drain hose avoids damage to your floor due
to water leakage. Read and follow these instructions.
Remove drain hose from the washer drum
1. Using locking pliers, squeeze hose clamp tabs together and
insert over the end of the drain hose.
2. Slide the drain hose onto the washer connection.
3. Once the drain hose is in place, release the pliers.

Secure Drain Hose

1. Drape the power cord over the washer top.
2. Move the washer to its final location.
3. Place the drain hose
in the laundry tub or
standpipe as shown.
4. Secure the drain hose using
the supplied beaded tie
strap.
20
4. The washer drain system can be installed using a floor drain,
wall standpipe, floor standpipe, or laundry tub.
Laundry tub drain or standpipe drain
Connect the drain hose form to the corrugated drain hose.
Snap either end of the drain hose form to the drain
hose at the point where the corrugation begins.
Bend drain hose over drain hose form and snap
into place.
NOTE: Hose must not extend more than
25 mm (1") past the end of the U bend.
To keep drain water from going back into the washer:
n Do not straighten the drain hose, do not force excess drain
hose into standpipe. Hose should be secure but loose enough
to provide a gap for air.
n Do not lay excess hose on the bottom of the laundry tub.
Floor drain
You may need additional parts. See "Alternate Parts. "
5. If the washer faucets and the drain
standpipe are recessed, put the
hooked end of the drain hose in
the standpipe as shown.
NOTES:
n Do not force excess drain hose
back into the rear of the washer.
n To avoid siphoning, do not seal
the drain hose into the standpipe.
n To avoid siphoning, do not seal or
put more than 114 mm (41/2") of the drain hose into drainpipe
or standpipe.
n It is the responsibility of the installer to install and secure the
drain hose into the provided plumbing/drain in a manner that
will avoid the drain hose coming out of, or leaking from, the
plumbing/drain.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Mle22pnMlg22pdMlg22pn

Tabla de contenido