Drain Facility; Flooring; Location Considerations; Alcove Or Closet Installation - Samsung WF395BTPA Serie Manual Del Usuario

Drain facility

The recommended height of the standpipe is 18 in/46 cm. The drain hose must be routed
through the drain hose clip to the standpipe. The standpipe must be large enough to accept the
outside diameter of the drain hose. The drain hose is attached at the factory.

Flooring

For best performance, you must install your washer on a solidly constructed fl oor. Wood fl oors
may need to be reinforced to minimize vibration and/or unbalanced load situations. Carpeting
and soft tile surfaces are contributing factors to vibration which can cause your washer to move
slightly during the spin cycle.
Never install your washer on a platform or weakly supported structure.

Location considerations

Do not install your washer in areas where water may freeze, since your washer will always retain
some water in its water valve, pump, and hose areas. Freezing water can damage the belts,the
pump, hoses and other components.

Alcove or closet installation

MINIMUM CLEARANCES FOR CLOSET AND ALCOVE INSTALLATIONS:
Sides – 1 in / 25 mm
Rear – 5.9 in / 150 mm
If the washer and dryer are installed together, the closet front must have at least a 72 in² (465
cm²) unobstructed air opening. Your washer alone does not require a specifi c air opening.
A. Recessed area
A
(2.5 cm)
B. Side view - closet or confi ned area

Undercounter installation (washer only)

WF395BTPA-03145B-02_EN_20120829.indd Sec2:15 WF395BTPA-03145B-02_EN_20120829.indd Sec2:15
1 in.
(2.5 cm)
1 in. 27 in. 27 in.
(68.6 cm) (68.6 cm)
40 in.
(101.6 cm)
Top – 17 in / 432 mm
Closet Front – 2 in / 51 mm
B
1 in. 2 in.
(2.5 cm) (5 cm)
1 in. 27 in. 1 in.
(2.5 cm) (68.6 cm) (2.5 cm)
17 in.
(43.2 cm)
32.3 in. 5.9 in.
(82 cm) (15 cm)
Installing your washer _15
2012-08-31 2012-08-31 12:36:19 12:36:19