eNet
Tecla sensora eNet con receptor vía radio
Switch-on brightness
Switch-on delay
Switch-off delay
Dim up ramp
Dim down ramp
Dimming adjustment time
Run-on time
32582713
J0082582713
1...100 %
Basic setting: 100 %
0 s ... 24 h
Basic setting: 0 s
0 s ... 24 h
Basic setting: 0 s
0 s ... 24 h
Basic setting: 0 s
0 s ... 24 h
Basic setting: 0 s
1...60 s
Basic setting: 4 s
0 s ... 24 h
Basic setting: 0 s
6/10
During brief operation, the out-
put switches on at the set
switch-on brightness.
Note: If the value is above the
set maximum brightness or
below the minimum bright-
ness, then the system will
switch to the appropriate limit
value.
The load switches on after a
delay. Repeated switch-on
commands restart the delay ti-
me. If the load has not yet
been switched on due to the
delay when a switch-off com-
mand comes, then the load
will remain off.
The load switches off after a
delay. Repeated switch-off
commands restart the delay ti-
me. If the load has not yet
been switched off due to the
delay when a switch-on com-
mand comes, then the load
will remain on.
Time between switch-on and
reaching switch-on brightness.
The light is switched on at mi-
nimum brightness and then
dimmed to the switch-on brig-
htness.
Note: If scenes are recalled or
switching uses logic modules,
the switch-on brightness is ap-
proached using so-called soft
dimming (not configurable).
Time until reaching minimum
brightness in case of switching
off (short operation). The light
is dimmed to minimum bright-
ness and then switched off.
Note: If scenes are recalled or
switching uses logic modules,
the system switches off di-
rectly.
Time from minimum bright-
ness until reaching maximum
brightness (dimming speed).
As soon as a run-on time has
been entered, the actuator will
no longer remain on perma-
nently, but only for the length
of the run-on time. The run-on
time is restarted if actuation is
repeated. This parameter is di-
rectly connected to the "Ma-
nual switch-off of run-on time"
parameter.
15.07.2016