Information For The Installer; Installation; Removal Of Packaging; Mounting The Machine - ASBER TECH-H500 Manual De Instrucciones

asberprofessional.com
This information is exclusively for the installer of the machine to avoid problems during installation. The in-
staller must be qualified to install the product. Incorrect installation of the product could damage the machinery

5.1 INSTALLATION

To install correctly, please observe the manufacturer's specifications
5.1.1

Removal of packaging

Remove packaging from the machine and check for damage during transportation. If any damage is ob-
served, immediately notify the supplier and the transport company. In the event of doubt, do not use the
machine until the problem has been assessed.
The machine should be moved using a fork-lift truck or similar to avoid damage to the structure. Transport
the machine to the installation location and then remove packaging.
All the packaging can be recycled. Dispose of packaging correctly.
5.1.2

Mounting the machine

5.1.3

Electrical connection

An AUTHORISED TECHNICIAN should always carry out the electrical connection of the appliance.
The legal standards in force in each country regarding connection to the mains should be taken into ac-
count.
 Check that the mains voltage corresponds to that indicated on the nameplate.
 The electric cable should be flexible, with an oil-proof covering, and it should not weigh less than

40
asberprofessional.com

5. INFORMATION FOR THE INSTALLER

PACKAGING (PLASTIC, EXPANDED POLYURETHANE, STAPLES, ETC...)
MUST NOT BE LEFT IN THE REACH OF CHILDREN, THEY ARE A
The machine has adjustable legs to allow it to be perfectly levelled (see diagram). For opti-
mum operation, it is essential that the machine is correctly levelled. This appliance is only
suitable for use with a fixed connection. The flooring on which the machine is to be installed
must be able to bear the full weight of the machine.
INSPECT FINAL LOCATION OF THE MACHINE PRIOR TO INSTALLATION
TO PREVENT DAMAGE DURING USE.
the cable in an ordinary sleeve made of standard polychloroprene or an equivalent synthetic elas-
tomer (H05RN-F).
The cross-section of the power cable must be suitable for the rated current of the machine. (See
table 3)
POTENTIAL HAZARD.
ENGLISH
.
.