ASBER TECH-H500 Manual De Instrucciones página 56

asberprofessional.com
Machine stops during opera‐
tion.
Machine stops and fills with
water when it is washing.
The machine does not start
with the wash cycle.
n
55
asberprofessional.com
Electrical installation over‐
loaded.
Machine
tripped.
The hood lifts.
Pressure
blocked.
Pressure switch faulty.
Overflow
mounted.
Hood is not closed properly.
Hood micro switch faulty.
NOTE: If a fault occurs and is not listed in the above table, please call
the technical service. The manufacturer reserves the right to modify
the technical characteristics with prior warning.
Call technical service to modify electrical installa‐
tion.
protection has Reset safety device and if it trips again, call tech‐
nical service.
Call technical service to adjust hood hinge
springs.
switch pipe
Empty the tub and clean thoroughly.
Call the technical service to replace it.
incorrectly
Mount overflow correctly.
Close the hood correctly and if it is seen to re‐
open alone, call the technical services to adjust
the spring hinges.
Call the technical service to replace it.
ENGLISH