Section 7. Winterizing - Jandy Pro Serie Manual Del Propietário

Page 14
4. Clean the lens and the enclosure of any remaining old silicone before
applying new silicone and replacing the lens. Replace the O-ring with
the new one provided. Attach the lens onto the fixture body. Tightly
secure the eight (8) screws indicated in the diagram below. Once all
screws are tight, slowly submerse in water, checking for any air bubbles
- quickly remove from water bubbles appear as it indicates the seal is
not water tight. retighten the screws and test for bubbles again.
SILICONE BEAD ON LENS
Apply a new silicone bead to
the lens with tube provided
after cleaning the lens and
body of old silicone.
5. Reset the fixture into the wall fitting and turn the power ON.
Section 7.
The water level should be lowered to approximately 12 inches below the
pool lights. Make certain that the water is drained out of the wall housing.
Consult a Local Swimming Pool Professional for proper winterization.
Minimum safeguard requires dropping the water level 2"-4" below the
light. At NO TIME should there be water removed from the pool without
checking ground water tables.
ENGLISH
Winterizing
Nicheless Underwater LED Lights | Owner's Manual
2
8
6
4
1
SCREW TIGHTENING DIAGRAM
3
5
7