Initial Operation; Maintenance And Cleaning; Environmental Protection - Bosch HF 0 602 207 Serie Instrucciones De Servicio

EURO • Printed in Germany • BA 3 609 929 765 • HF/GGS • GB • OSW 09/00
HF-GGS - Buch Seite 3 Donnerstag, 7. September 2000 9:03 09
Type 0 602 228 361, ...364, ...371, ...374, ...377:
D To loosen the collet 4, turn the grinding spin-
dle 3 until the slot of the eccentric bolt is visible in
the hole of the spindle housing. Insert the blade of
the offset screwdriver into the slot of the eccentric
bolt and turn in such a manner, that the collet 4 is
pressed out of the grinding spindle 3.
Insert the clamping shaft of the grinding tool to the
stop into the collet chuck.
To clamp the grinding accessory, turn the offset
screwdriver in such a manner, that the collet 4 is
pulled into the grinding spindle 3. Check for tight
seating of the grinding tool bit.
If the grinding accessory can not be clamped
tight, loosen the eccentric tension with the offset
screwdriver, screw the collet 4 somewhat in or out
and retighten the grinding accessory with the off-
set screwdriver again.

Initial Operation

The voltage and frequency of the power source
must agree with those given on the nameplate of
the machine.
Test run!
Check the grinding tool before use. The
grinding tool must be flawlessly mounted
and be able to rotate freely. Perform a test
run of at least 30 seconds without load. Do
not use damaged, out-of-round or vibrating
grinding tools.
Operating Instructions
Wear safety goggles.
Optimum grinding results are achieved when the
grinding tool is moved uniformly back and forth
with light pressure.
Pressure that is too strong reduces the perform-
ance capability of the machine and causes the
grinding tool to wear more quickly.
Do not continue to use out-of-round grinding
tools. Dress with a dressing stone (optional ac-
cessory) or replace.
English - 3

Maintenance and Cleaning

Before any work on the machine itself, pull
the mains plug.
For safe and proper working, always keep
the machine and the ventilation slots clean.
If the machine should fail despite the rigorous
manufacturing and testing procedures, repair
should be carried out by an authorised after-sales
service centre for Bosch power tools.
In all correspondence and spare parts orders,
please always include the 10-digit order number
given on the nameplate of the machine.
Guarantee
We guarantee Bosch appliances in accordance
with statutory/country-specific regulations (proof
of purchase by invoice or delivery note).
Damage attributable to normal wear and tear,
overload or improper handling will be excluded
from the guarantee.
In case of complaint please send the machine,
undismantled, to your dealer or the Bosch Serv-
ice Centre for electric power tools.

Environmental Protection

Recycle raw materials instead of disposing as
waste.
The machine, accessories and packaging should
be sorted for environmental-friendly recycling.
These instructions are printed on recycled paper
manufactured without chlorine.
The plastic components are labelled for catego-
rized recycling.