Testing The Battery; Using The Pole Pruner; Holding And Controlling The Pole Pruner; Limbing - Stihl HTA 65 Manual De Instrucciones

English
► Switch on the pole pruner.
Chain oil is thrown off the chain and is visible on the light
surface. Chain lubrication is operating properly.
If no chain oil can be seen:
► Fill up with chain oil.
► Check chain lubrication again.
► If chain oil is still not visible on the light surface: Do not
use your pole pruner and contact your STIHL servicing
dealer for assistance. Chain lubrication is defective.

11.6 Testing the Battery

► Press button on battery.
The LEDs glow or flash.
► If the LEDs do not glow or flash: Do not use the battery
and contact your STIHL servicing dealer.
There is a malfunction in the battery.

12 Using the Pole Pruner

12.1 Holding and Controlling the Pole Pruner

2
► Connect the carrying ring (2) to the carabiner (1).
60
► Hold the pole pruner with one hand on the control handle
► Hold the pole pruner firmly with your other hand on the

12.2 Limbing

Cross-cut
1
► Position the stop (1) against the branch.
► With the chain running a full speed, pivot the guide bar
► Cut through the limb with the bottom of the bar.
– wrap your thumb around the control handle.
handle hose - wrap your thumb around the handle hose.
1
downward against the limb.
12 Using the Pole Pruner
0458-766-9821-D