Driving Treads; Status Indicator Light And Sounds - ECOVACS ROBOTICS WINBOT8 Manual De Instrucciones

4. Maintenance

4.3 Driving Treads

Move the Power Switch to the "I" position.
Press and hold the robot's START/PAUSE
Button for 5 seconds to stop the Fan.
5. Status Indicator Light and Sound
Indicator
Status Indicator Light
flashes GREEN
Status Indicator Light
flashes BLUE
Status Indicator Light
glows a continuous BLUE
Status Indicator Light
glows RED
WINBOT Emits beeps
14
EN
ON
Back Up Battery is low and is charging. WINBOT will not clean until
the Back-Up Battery is properly charged.
WINBOT 8 is powered ON and is ready to be placed on the glass.
WINBOT 8 has successfully adhered itself to the glass and is ready
to clean.
WINBOT 8 has a problem. Please refer to Section 6,
Troubleshooting, for details.
WINBOT 8 beeps in following situations:
WINBOT 8 is powered ON.
WINBOT 8 finishes cleaning.
WINBOT 8 has a problem.
Turn WINBOT 8 over. Inspect the Driving
Treads by using the
Remote Control. Stop the Driving Treads if
dirt is seen on the Treads.
Move the Power Switch to the "O" position.
Clean any dirt on the Driving Treads with the
provided Finishing Cloth.
Description
and buttons on the