Specifications - Stihl TS 440 Manual De Instrucciones

English

Specifications

EPA / CEPA
The Emission Compliance Period
referred to on the Emissions
Compliance Label indicates the number
of operating hours for which the engine
has been shown to meet Federal
emission requirements.
Category
A = 300 hours
B = 125 hours
C = 50 hours
CARB
The Emission Compliance Period used
on the CARB-Air Index Label indicates
the terms:
Extended = 300 hours
Intermediate = 125 hours
Moderate = 50 hours
Engine
STIHL single cylinder two-stroke engine
Displacement: 4.07 cu. in.
(66.7 cm
Cylinder bore: 1.97 in. (50 mm)
Piston stroke: 1.34 in. (34 mm)
50
Engine power accord -
ing to ISO 7293:
Idling speed:
Maximum spindle
speed:
Ignition system
Electronic magneto ignition
Spark plug
(suppressed):
Electrode gap:
Fuel system
All position diaphragm carburetor with
integral fuel pump
Fuel tank capacity:
Air filter
Main filter (paper filter) and flocked wire
mesh auxiliary filter
Weight
Without fuel, without abrasive cutting
wheel, with electronic water control
3)
24,5 lbs (11,1 kg)
Abrasive cutting wheels
4.3 hp (3.2 kW)
at 9000 rpm
2700 rpm
The quoted maximum permissible
operating speed of the abrasive cutting
wheel must be greater than or equal to
2750 rpm
the maximum spindle speed of the cut-
off machine used.
Outside diameter:
Max. thickness:
Bosch WSR 6 F
Bore diameter/spindle
0.02 in.
diameter:
(0.5 mm)
Tightening torque:
Composite cutting wheels
Minimum outside diameter of
thrust washers:
Max. possible depth of cut: 4.9 in.
24.0 oz
(0.71 l)
STIHL has developed a composite
cutting wheel suitable for dry cutting
metals with the TS 440. STIHL has not
developed a composite cutting wheel for
cutting other materials with the TS 440,
or for wet cutting.
Composite cutting wheels rated for
traditional, high-speed cut-off machines
should not be used with the TS 440,
which has a maximum spindle speed of
2750 rpm.
WARNING
The TS 440 should not be used for wet
cutting when equipped with a composite
cutting wheel, as wet cutting increases
the risk of wheel failure and severe or
fatal personal injury and property
damage.
14 in.
(350 mm)
0.189 in.
(4.8 mm)
0.787 in.
(20 mm)
22 lbf ft
(30 Nm)
4.06 in.
(103 mm)
(125 mm)
TS 440