Rx-5 Light M-Link Receiver; Handling; Transmitter Controls; Receiver Controls - Multiplex SMART SX Manual De Instrucciones

_________________________________________________________________________________________________________
6.2

RX-5 light M-LINK receiver

Servo channels:
Connector system:
Receive system:
Operating voltage:
7. H
ANDLING
7.1

Transmitter controls

Elevator / rudder stick
(Mode 1 + 3)
Throttle / aileron stick
(Mode 2 + 4)
Rudder trim
(Mode 1 + 3)
Aileron trim
(Mode 2 + 4)
Switched channel 6
(Mode 2 + 4)
Elevator trim
(Mode 1 + 3)
Transmitter with integral buzzer for audible
feedback
Battery compartment with cells fit-
ted (always maintain correct cell
polarity, as shown in this photo)
PC communication port with USB lead (#
85149).
SMART SX
5
UNI
2.4 GHz FHSS
3.5 V ... 9.0 V
Power supply:
Permissible operating
temperature range:
Weight:
Dimensions (L x W x H): approx. 34 x 19.5 x 11 mm
Integral IOAT aerial
On / Off switch (button)
with Status LED
Multifuncti-
on button
7.2

Receiver controls

Status LED
2.4 GHz aerial, do not bend sharply,
deploy active end in a straight line
7.3

Transmitter aerial

The transmitter is fitted with an aerial exploiting the new,
patented IOAT tech-nology. The integral aerial exhibits a
radiation pattern which is ideal for the user, and completely
new in the sphere of RC system transmitters: all the radi-
ated power is effectively concentrated in the flight sector.
Page 21
4 - 6 NiXX cells, 2S LiXX
o o
- 20 C ... + 55 C
approx. 7 g
Switched channel 6
(Mode 1 + 3)
Elevator trim (Mode 2 + 4)
Throttle / aileron
stick (Mode 1 + 3)
Elevator / rudder
stick (Mode 2 + 4)
Aileron trim
(Mode 1 + 3)
Rudder trim
(Mode 2 + 4)
SET button
Servo sockets,
channels 1 - 5