Silvercrest KH 2431 Instrucciones De Uso página 75

Activating the remote control battery
Exchanging the remote control battery
GB
MT
Connection to an external amplifi er
VHF - Wire aerial
Connecting the headset
72
The battery for the remote control is already inserted on delivery.
♦ Activate the battery by removing the insulation strips.
♦ With a fi ngernail press the notch (A) to the right while
at the same time pulling the battery compartment out.
♦ Insert a 3 V battery, type CR 2032, into the battery
compartment.. The side with the marking "+" must be
facing upwards.
♦ Slide the battery compartment back into the remote
control.
NOTE
► This device is equipped with a LINE OUT output (audio signal processed
by an internal amplifi er) and with a PHONO OUT output (non-amplifi ed
audio signal, and only for playback of records).
♦ Connect the cinch cable to the LINE OUT connection sockets
the AUX IN connection of the external amplifi er. For this, pay heed to the
operating instructions for the external amplifi er.
♦ Connect the cinch cable to the PHONO OUT connection sockets
to the PHONO input of the external amplifi er. For this, pay heed to the
operating instructions for the external amplifi er.
IMPORTANT
Potential damage to the external amplifi er!
In the case of a false connection of the device, the amplifi er may be
damaged.
► Do not connect the LINE OUT output of the device with the PHONO
input of the amplifi er.
♦ Completely unwind the wire aerial
♦ If desired, connect your headphones (with 3.5 mm jackplug) to the connec-
tion socket . The loudspeakers then switch off automatically.
Setting up and connecting
for radio reception.
and to
and
KH 2431