Maintenance And Troubleshooting - Tecno-gaz MULTISTERIL 2200S Manual Del Usuario

ENGLISH
MAINTENANCE AND TROUBLESHOOTING
Wait for the cleaner to cool down and unplug the power cable before cleaning.
To clean the device simply follow the basic sanitary rules applied when cleaning similar
equipment.
USE DETERGENTS THAT ARE SUITABLE FOR STAINLESS STEEL.
Cleaning the inlet filter (Pct. 3):
The water inlet (solenoid valve) is provided with a filter. Periodically disconnect the
water intake hose and clean the filter with a cloth.
Cleaning the outlet filter (Pct. 3):
The filter may contain water — place a basin or a sponge beneath the filter before you
take it out. Clean the filter by blowing air on it or by adding water from the inside to
remove the residues on the outside. Clean the filter holder with a cloth.
A clogged filter will obstruct draining the water in the tank
unscrew the filter without removing it, press
message and wait for the tank to empty. Then clean the filter as described above.
Changing the pump hose:
The pump hose needs to be changed periodically, at intervals
depending on:
We recommend having the hose replaced every year by qualified
personnel.
Carefully follow the instructions below:
‐ Close the valve upstream every night or whenever the cleaner remains unused for
a number of days.
‐ Do not perform maintenance or repairs inside the cleaner. Disassembling the
cleaner constitutes tampering.
‐ Maintenance and repairs must be carried out only after disconnecting the
cleaner from the power and water mains.
‐ All servicing must be carried out by qualified personnel only.
Maintenance:
‐ Frequency of use
‐ Type of solutions used
Cleaning:
for 5 seconds to cancel the error
20
. If this happens,