Built-In Timer; Maintenance; Declaration Of Compliance - ESPA evopool SilenPlus Manual De Instrucciones

• Configuring Backwash plus.
The maximum and minimum speeds are set, al- The maximum and minimum speeds are set, a
ways maintaining a differential of 20 Hz between maintaining a differential of 20 Hz between
them
· Minimum = 1,600/2,320 RPM (20/40 Hz), [= fs] Minimum = 1,600/2,320 RPM (20/40 Hz), [= fs]
· Maximum = 1,740/2,900 RPM (30/50 Hz) Maximum = 1,740/2,900 RPM (30/50 Hz)
• Configuring the Mixed Cycle (Manual only) Configuring the Mixed Cycle (Manual only)
The factory setting is 2,320 RPM (40 Hz) The factory setting is 2,320 RPM (40 Hz)
· Minimum = 1,600 RPM (20 Hz)
· Maximum = 2,900 RPM (50 Hz), [= fs] 2,900 RPM (50 Hz), [= fs]
If M and F are not pressed for 5 seconds the new If M and F are not pressed for 5 seconds the new
values are stored and the configuration mode is values are stored and the configuration mode is
deactivated.
SilenPlus can also be entirely configured u can also be entirely configured us-
ing the EspaEvopool application.

7. BUILT-IN TIMER

The SilenPlus pump has an internal clock that can
operate as a start and stop timer, making external operate as a start and stop timer, making external
programming unnecessary.
With this function, SilenPlus can operate entirely
independently.
WARNING: the programming and maint WARNING: the programming and mainte-
nance of the timer is only possible using an nance of the timer is only possible using an
Android device with Bluetooth connectivity id device with Bluetooth connectivity
and the EspaEvopool app, available from
www.espa.com
7.1 Activating the timer.
DANGER.Electrocution risk.
Never open the SilenPlus cover without tur
ing the power supply off at least 5 minutes ing the power supply off at
before hand.
• Lift the SilenPlus cover by loosening the 4 cover by loosening the 4
screws. (See figure 5)
• Activate the Timer using the mini Activate the Timer using the mini-switch, moving
it to the "ON" position.
• Replace the cover and fix it with the 4 screws. Replace the cover and fix it with the 4 screws.
Torque: 0.5 Nm.
7.2. Time setting.
Link SilenPlus with the external device using Blu with the external device using Blue-
tooth, following the instructions on the device. tooth, following the instructions on the device.
Run the EspaEvopool app and follow its indications. app and follow its indications.
application.
an internal clock that can
can operate entirely
app, available from
cover without turn-

8. MAINTENANCE

ControlSystem:
If ControlSystem is is
SilenPlus it may be necessary to it may be necessary to replace the battery.
Proceed as in section 4.2.
It is a 1.5 V, CR2450 type battery. It is a 1.5 V, CR2450 type battery.
SilenPlus:
Our SilenPlus equipment is maintenance free. equipment is maintenance free.
Clean the equipment with a damp cloth and without Clean the equipment with a damp cloth and without
using aggressive products.
In freezing weather, take the precaution of In freezing weather, take the pr
emptying the pipes.
If the equipment is going to be inactive for a If the equipment is going to be inactive for a
long time, you are recommended to disma long time, you are recommended to disman-
tle it and keep it in a dry, well tle it and keep it in a dry, well-ventilated place.
WARNING: in case of a breakdown, the WARNING: in case of a breakdown, the
equipment must only be touched by an equipment must only be touched by an
authorised service technician. service technician.
The list of official technical services can be found at The list of official technical services can be found at
www.espa.com.
When the time comes to throw the product away, it When the time comes to throw the product away, it
does not contain any toxic or polluting material. The does not contain any toxic or polluting material. The
main components are duly identified so you can main components are duly identified so you can
dispose of them selectively. selectively.

9. DECLARATION OF COMPLIANCE

9. DECLARATION OF COMPLIANCE
We declare, under our own responsibility, that the We declare, under our own responsibility, that the
products in this manual meet the following Commu- products in this manual meet the following Comm
nity directives and technical regulations: nity directives and technical regulations:
- Directive 2004/108/EC (EMC) Directive 2004/108/EC (EMC)
· Regulations EN 61000-6
- Directive 2006/95/EC (Low Voltage) Directive 2006/95/EC (Low Voltage)
· Regulation EN 60730-1 and EN 60730
Pere Tubert (Technical Manager) Pere Tubert (Technical Manager)
ESPA 2025, SL ESPA 2025, SL
Ctra.deMieres, s/n –
Girona - Spain
11
EN
not not communicating communicating with with
6-1 and EN 61000-6-3
1 and EN 60730-2-6
– 17820 Banyoles
Spain