Help with Setup
My iPod is in the Dock and playing,
but I can't hear any music.
• Make sure the S715i is on. (Power LED should
be green.) To turn on the S715i, press the Power
button on the remote or the Power button
located on the front of the S715i .
• Battery power may be low. Plug in the AC power
supply to listen to music while you charge
the batteries.
• Try adjusting the volume level using the volume
buttons on the remote or those on the speaker.
• Try adjusting the volume level on your iPod
or iPhone.
• Try turning off the Sound Check feature on
your iPod.
• Download the latest version of iTunes
(available at apple.com) and upgrade your iPod
to the latest iPod firmware.
There isn't a Universal Dock adapter for
my iPod.
• Your S715i speaker does not need any Universal
Dock adapters. Its unique design allows full
support for your iPod without having to swap out
adapters for different iPods.
Logitech
• If you have a first, second, or third generation
iPod, you need to use the Auxiliary input on
the back of the S715i. To do so, you will need
to purchase a separate cable to connect
your iPod to the Auxiliary input. (First and second
generation iPod models do not have a dock
connector. Third generation iPod models are not
supported by the S715i's Universal Dock).
The remote isn't working.
• Point the remote directly at the S715i .
• You need to be within 30 feet of the S715i .
• Make sure the remote sensor isn't being blocked.
(It is located above the power LED.)
• The S715i may be in Standby or Sleep Mode.
Press the Power button on the remote or
the Power button on the front of the S715i
to wake up the speaker.
• Try using a fresh battery in the remote.
My iPod screen says "OK to disconnect"
or "Accessory attached."
Depending on your iPod model, these messages
will appear when playing iPod playlist presets.
Once the music has started playing, the iPod screen
will return to normal.
For the most up-to-date troubleshooting
information, visit: w ww.logitech.com
Rechargeable Speaker S715i
®
English
9