melitta Caffeo Solo & Milk Manual De Instrucciones página 22

Ocultar thumbs Ver también para Caffeo Solo & Milk:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 74
Preparation
Preparation
■ Fill the water tank with fresh water every
day. The water tank must always be
fi lled with enough water for the operation
of the appliance.
■ Fill the bean container preferably with
espresso beans or bean mixtures for
fully automatic coffee machines.
Do not use any ground, glazed,
caramelised, or otherwise sugar-coated
coffee beans.
Setting the dispensed quantity and
strength
■ Turn the coffee quantity regulator 4 to
infi nitely adjust the dispensed quantity.
Regulator all the way
to the left = 30 ml per cup
Regulator all the way
to the right = 220 ml per cup
■ Press the
strength is adjusted. The strength is
shown by the beans on the display 10
(from
= mild to
Dispensing coffee or espresso
One or two cups can be dispensed
simultaneously.
■ Switch on the device.
■ Place one or two cups under the outlet.
■ Preparing one cup: Press the
button once.
■ Preparing two cups: Press the
button twice.
■ Press the button again to cancel the
coffee dispensing.
22
button until the desired
= strong).
Operating Instructions: Melitta
Preparing milk froth and heating
milk and water
WARNING
There is a risk of burn injuries and
scalding due to hot steam and the
hot steam pipe!
▶ Never reach into the escaping steam.
▶ Avoid direct skin contact with hot water
and the hot steam pipe.
▶ Never touch the steam pipe during
use or immediately after use.
The steam pipe is used to prepare milk
froth, to heat milk or to dispense hot water.
Preparing milk froth
If possible, use cold milk with a high
protein content.
■ Switch on the device.
■ Push the outer shell of the steam pipe
down in the direction shown by the
arrow (Image K, 1).
■ Press the
button.
the appliance is heating up. After the
heat-up phase,
■ Fill the vessel with milk to maximum one
third.
■ Hold the vessel under the steam pipe.
In doing so, ensure that the tip of the
steam pipe is immersed in the milk.
■ Turn the valve switch 11 clockwise until
it stops.
is fl ashing. The hot steam
froths the milk and heats it up.
■ Turn the valve switch 11 anticlockwise
until it stops. The frothing is completed.
■ Rinse the steam pipe after each use.
Solo
& Milk | 1829-0618 | 2018-08
®
®
fl ashes while
is illuminated.

Publicidad

Tabla de contenido
loading

Tabla de contenido