Ascaso Steel Serie Manual Del Usuario página 21

basket up to the rim.(See picture 2B)
To tamp and fill the coffee again.
Points 1.2.4.5.6 and 7 as in the above
section.
It is normal for the coffee grounds
to be very wet or a soup-like
consistency if the filter holder is
removed within one to minutes after
brewing
picture 2A
1. Connect the coffee machine with
the main switch
Connect the machine with the
main switch in position (I), or
1
(II) to connect the DUO steam
group as well. Place the filter
holder (with filter) in the group.
TRIO model: Also activate the
switch for the steam group
2. Wait for the pilot light
off (approx. 1.5 minutes). This
means the coffee machine has
reached the ideal temperature.
Press coffee switch
water run out. Do this before
making the coffee. This will
remove residue and balance the
temperature to create optimum
working conditions.
3. Fill the coffee filter basket (1
picture 2B
in position (I).
1
.
18
to switch
6
and let
2
picture 3
or two coffees according to
requirements), Three-quarter size.
The filter must be filled to 3/4 of
its capacity, once pressed.(see
picture 2A)
4. Clean off the remains of coffee
that have been deposited on the
edges of the filter basket so that it
fits perfectly.
5. Place the filter holder
group starting from the left
8
and turning towards the right with
enough pressure at the end. (see
picture 3)
6. Put the cups or cup on the grille
and switch on the coffee switch
.
2
7. When the coffee has finished
being made, switch off the coffee
switch .
2
If using POD:
Use the specific filter holder • or pod
filter (option).(See picture 4)
Points 1, 2, 5, 6, 7 and notes as in the
above section.
Fixed holder-pod only
Points 1 and 2 as in the section on
ascaso
into the
7
picture 4
Dibujo 4
Dibujo 4
picture 5
21