Integrated Descaling Programme - melitta Caffeo CI Manual De Instrucciones

Integrated descaling programme

Warning!
The descaling agent can cause skin
irritations
Comply with the safety instructions
and the dosing information specified
on the descaling agent packaging.
The integrated descaling programme
(takes about 25 minutes) removes lime
residues inside the appliance. The
progress bar on the text display 4 shows
the current progress of the descaling
programme.
The descaling programme should be
performed every 3 months, at the latest,
however, when a corresponding message
appears on the text display 4.
Only use Melitta
®
• Call up the Care sub-menu.
• Select Descaling in the menu.
• Select Start in the menu. The descaling
programme will start.
• When the message "Empty tray and
vessel" appears on the text display 4,
empty the the drip tray and the coffee
grounds container and reinsert them.
• When the message "Remove water
reservoir" appears on the text display 4,
flip up the lid of the water reservoir 6 and
pull the water reservoir 6 up and out of
the appliance, and empty it.
• If a water filter is used, remove it from
the water reservoir.
• Add the descaling agent to the water
reservoir according to the instructions on
the packaging.
• Reinsert the water reservoir 6.
34
BA_CI_082016.indd 34
ANTI CALC.
• Place a vessel (min. 0.7 l capacity)
under the outlet 3.
• Press the rotary switch 10 to confirm.
• Connect the tube to the drip tray and to
the outlet (Image D).
• Press the rotary switch 10 to confirm.
The descaling programme will continue
(approx. 20 minutes), water flows out of
the outlet and in the drip tray inside the
appliance.
• When the message "Empty tray and
vessel" appears on the text display 4,
empty the vessel under the outlet and
the drip tray. Then reinsert them both.
• When the message "Refill water
reservoir" appears on the text display 4,
flip up the lid of the water reservoir 6 and
pull the water reservoir 6 up and out of
the appliance.
• Rinse the water reservoir 6 thoroughly.
• Fill the water reservoir 6 with tap water
up to the max. mark.
• Reinsert the water reservoir 6.
• The descaling programme will continue
(approx. 5 minutes), water flows out of
the outlet and in the drip tray inside the
appliance.
• When the message "Empty tray and
vessel" appears on the text display 4,
empty the vessel under the outlet and
the drip tray. Then reinsert them both.
• After the descaling programme is
finished, the appliance is ready for
operation.
21.09.2016 07:24:43