MR. JUICE
16
. Remove any large pips or seeds
. Always pre-wash food before juicing.
. Do not overstuff the hopper or force food in. Insert food slowly to allow
juicer time to work. The pusher is only be used if food becomes stuck.
5. Switch the power button to "ON".
. Insert food slowly to allow juicer time to work.
. Do not overstuff the hopper or force food in. The pusher is only to be
used if food becomes stuck.
6. When you are finished switch the power button to 'OFF'.
D. If the machine becomes clogged and inoperable.
1. Turn the machine off and press the reverse button for a few seconds
then try operating again. Note: The reverse button works with a 'pulse'
motion.
2. If the reverse button does not work turn off the machine and switch off
at the power point. Disassemble the unit to dislodge any material then
reassemble as per the instructions and try again.
E. How to disassemble and clean the unit:
1. Switch off the unit.
2. Twist the bowl and hopper as one piece to the right so that the arrow on
the hopper moves away from the close position. Lift off.
3. Disassemble the parts in the order show by the diagram.
4. Use the brush to clean all of these parts thoroughly in warm soapy water
then dry thoroughly.
5. Use a damp cloth to wipe down the base of the unit.
CLEAN TIPS:
•
Periodically remove the silicone brushes from the spinning
brush and clean thoroughly before reassembling.
•
Thoroughly clean immediately after each use to minimize
staining.
•
Pull out the rubber stopper on the base of the bowl to clean
bowl effectively. Always ensure the rubber stopper is re-
inserted prior to juicing otherwise it may cause a leak.
•
Do not use harsh abrasives or chemicals to clean the juicer.
•
Do not clean in the dishwasher.