TURNING ON AND ADJUSTING THE CONVENTIONAL OVEN
Grill:
When using the grill the oven door must be ajar.
A protection sheet is supplied with the oven. Fix it under the control panel to protect against overheating (see Fig. D).
Remove this protection sheet only once it has cooled down. The grill gets hot when it is working so you must wear
protective gloves to remove it and to prevent burns.
Turn the oven control knob round to the
GB
LIGHTING AND ADJUSTING THE OPEN RINGS
On the front panel, above each knob, there is a symbol which indicates to which burner the
knob
corresponds.
To light, turn the knob to the left from position "0" to the
pushed down and press the button with the
The knob must be kept pushed down for a few seconds and then released . The flame may
go out, in which case it is necessary to repeat the procedure. By turning to the
the burner is brought to the minimum. To put out the burner, turn the knob back into the "0"
position
Oven:
Turn the control knob to the right and set the temperature wanted.
To turn the oven off, turn the knob to the left to position 0.
When you want to use the oven with the top and the bottom heating element, thermo
stated, position the knob on the
When you want to use the oven with only the bottom heating element, thermo stated,
position the knob on the
Caution: when the oven is on the door must be kept shut otherwise the knobs and
protection sheet could get hot and be damaged.
symbol.
IE
IT
CH
symbol until the gas lights.
symbol.
symbol.
40
symbol (see figure); keep it
position,