Maintaining And Cleaning The Product - Dometic PLB40 Instrucciones De Uso

Maintaining and cleaning the product

Problem
The display shows the warn-
ing symbol and the fuse
blown symbol flashes. An
error sound is continuously
beeping for 30 seconds.
The display shows the warn-
ing symbol and the charge
arrow symbol flashes. An
error sound is continuously
beeping.
The display shows the warn-
ing symbol. The discharge
arrow and either the USB or
2-pin or DC symbol flashes.
An error sound is beeping for
60 seconds.
The battery symbol is flash-
ing. An error sound beeps
every 3 seconds for 10 times.
After the beeps the device
switches off automatically.
8 Maintaining and cleaning the product
A
NOTICE! MATERIAL DAMAGE.
Do not use sharp or hard objects or cleaning agents for cleaning as
these may damage the product.
Do not use alcohol based cleaning materials for cleaning the gloss
top cover.
➤ Occasionally clean the product with a damp cloth.
14
Cause
The DC output fuse has
blown. Additionally the DC
symbol flashes in the display.
The 2-PIN fuse has blown.
Additionally the 2-PIN
symbol flashes in the display.
The input voltage of the
charger is wrong.
Over current protection was
triggered.
Short circuit protection was
triggered.
The battery capacity is 0 %.
Remedy
Turn the device off.
Change the DC fuse (chapter
"Replacing fuses" on
page 13).
Turn the device off.
Change the 2-PIN fuse (chap-
ter "Replacing fuses" on
page 13).
Turn the charger off. Connect
a charger with the standard
charge voltage (chapter
"Technical data" on
page 15).
Turn the device off. Release
some of the load before
switching the device on
again.
Turn the device off. Clear the
short circuit before switching
the device on again.
Charge the device.
PLB40
EN