CMT ORANGE TOOLS CMT900 Manual De Instrucciones página 11

SHELF SUPPORT DRILLING AA
Drilling shelf supports holes
The division and side work piece of the cupboard body are shown in Fig. 8.
The "n" parameter in the illustrations shows the number of holes starting from the second hole at the
0 stop (Fig. 10 and 12).
- Before drilling, always make certain the template stops are perfectly up against the work piece.
- Always match the template with the work piece starting from one edge (upper or lower side).
- Check drilling depth before drilling.
- If the drilled hole is not clean, sharpen the drill bit.
Fig. 8
www.cmtorangetools.com
11