CMT ORANGE TOOLS CMT900 Manual De Instrucciones página 9

MAKING DOWEL AND SCREW JOINTS ON A FLAT SURFACE AA
Insert the stop in the 0 hole at the edge of the template. Position the CMT900 on the work piece
so that the edge stop touches the front edge of the work piece and the axis of the template holes is
aligned with the line drawn on the work piece (Fig. 5).
2
Fig. 5
Make certain that the stop ring is up against the front edge of the work piece and the centre axis
of the template holes crosses the line drawn on the work piece. Now tighten the CMT900 using the
clamps. Set the drilling depth of the adaptor chuck at 15mm with an 18mm thick work piece. Insert
the adaptor chuck with the relative drill bit in the holes and start drilling the dowel holes (Fig. 5).
Drill deep holes gradually so that chips can be removed. Make certain the drill rotates in the correct
direction – these are right-hand bits.
www.cmtorangetools.com
9