Patek Philippe WORLD TIME CALIBER 240 HU Manual Del Usuario página 7

CHANGING THE
TIME ZONE
When traveling to a different time zone, you merely
need to actuate the time-zone selection pusher
10 o'clock until the city that represents the new time
zone is in the 12 o'clock position .
Three movements take place each time you press the
pusher: the hour hand moves clockwise in one-hour
steps while the city disk
both advance counterclockwise by one position.
These corrections do not influence the motion of the
minute hand .
Note: The city disk does not move as long as you remain
in the same time zone, but the 24-hour disk, connected to
the dial train, will gradually rotate counterclockwise. The
interaction of the city disk and the 24-hour disk allows
you to read the time in any of the world's 24 time zones
whenever you wish.
10
at
and the 24-hour disk
CAUTION
Please wind the watch and set the time before
you put the watch on. This prevents lateral
pressure on the winding stem. Please use
your fingernails to pull the crown out and
turn it gently between two fingertips.
Never pull out the crown in a humid envi-
ronment or underwater: the water resist-
ance of your watch is assured only when
the crown is pushed home.
Press the time-zone selection pusher all the
way in and release it fully before you press
it again.
If your watch has stopped running, rewind
it by hand before performing any correc-
tions or adjustments (about 10 clockwise
turns of the crown).
11