Before first use
•
Clean the inside and outside of the appliance with water
and a mild detergent before putting any food in it. Clean
the ice maker too.
•
After the appliance has been levelled and cleaned, wait
for at least 6 hours before connecting it to the power
supply. Make sure the socket meets the requirements
and connect it to an earthed socket outlet.
•
Set the temperatures for the compartments or use the
Fuzzy mode.
•
Load the appliance with food after it has been running
for a while and the inside is cool enough.
Fig. 2-2
4
5
6
7
9
10
Fig. 2-3
About the Fresh Food Compartment
It is recommended to leave storage space between the foods
for good cold air circulation. The temperatures in the refrigera-
tor are slightly warmer near the top and colder near the base.
Foods that are likely to perish quickly should be placed to-
wards the rear of the appliance – where it is coolest.
Suggestions for storage (Fig.2-2):
1.
Eggs, cans, tins, condiment,etc.
2.
Butters, cheeses, tea,children's foods, etc.
3.
Drinks and all kinds of bottled foods.
4.
Pickled foods, cans.
5.
Meat foods,small foods.
6.
Fast foods,easy odour foods,dairy.
7.
Flour foods, cans,dairy, bean curd.
8.
Press different keys for vegetable, meat, fruit, fish,
1
etc.
9.
Fruits, vegetables or salads,etc.
10. Cooked meats, sausage, etc.
Shelves
The height of the shelves can be adjusted to fit your storage
2
needs.
The shelves will not pull out accidentally when you remove
foodstuff from the appliance.
When adjusting the height of a shelf, first remove any
food placed on the shelf.
3
Remove The Shelves
The height of the shelf can be adjusted to fit your needs
(Fig.2-3). When it needs to be cleaned, it can be also re-
moved as follows:
Lift both front and rear of the shelf along the direction ① . With
the front tilted upwards over the rear, then pull it out along the
direction ② . Ensure that all ends of a shelf are level.
When repositioning, operate as the reverse steps.
The Light
The LED interior light comes on when the door is opened.
The performance of the light is not affected by any of the ap-
pliances other settings.
7