Troubleshooting Guide; Disposal Information - MIRKA DEOS 383X Instrucciones De Manejo

Ocultar thumbs Ver también para DEOS 383X:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Troubleshooting guide

Symptom
The sander LED (right) is flashing
between red and green.
No light from sander LED (right) when
switched on.
The sander LED (right) is red and the
sander slows down to 5,000 rpm when
sanding.
The sander LED (right) is red and rpm is
slightly reduced.
The sander has stopped and LED (right)
is red.

Disposal information

DANGER
Disposal guidelines for old appliances . Render redundant power tools unusable by removing the
power cord . Only for EU countries . Do not dispose of electric tools along with household waste .
According to European Directives 2002/95/EC, 2012/19/EU + 2003/108/EC on waste electrical and
electronic equipment and their implementation under national law, electric tools that have reached
the end of their life must be collected separately and taken to an environmentally compatible
recycling facility .
Possible cause
Connected to a mains outlet with wrong
voltage .
Power cord not properly attached to the
sander or to the mains socket .
Temperature too high in the sander . Too
heavy long-term load .
Too heavy short-term load .
The tool is in safety mode due to high
temperature .
Mirka® DEOS • 81 x 133 mm (3" x 5") & 70 x 198 mm (3" x 8")
Solution
Connect the sander to a mains outlet that
matches the nominal voltage of the tool .
Connect it properly .
Reduce the load on the sander for some
time and the sander will speed up again .
Use lighter load and the LED (right) will
automatically change to green .
Wait until the tool has cooled down .
en
13

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Deos cv 353x

Tabla de contenido