Fitting The Casing - Sime 1R OF Serie Manual De Uso

– insert the bead of putty in the groo-
ve of the section that has just been
assembled, and then proceed to joi-
ning up the other sections until the
body is completed.
– replace the tie-rods in their original
position;
– replace the two lower front and
upper panels;
– install the smoke chamber and the
flange as in figure 6/a.
NOTE: before proceeding to con-
nect the system, test the boiler
block with a water pressure of 7.5
bar and fill in the "testing certifica-
te" completely.
2.6

FITTING THE CASING

The casing and the control panel are
supplied in separate cardboard packa-
Safety thermostat probe
Sonda termostato sicurezza
8
7
11
10
11
2
5
KEY
1 Pin
2 Flange ø 35/87
3 Biconical nipples
4 Staybolt L. 900 + staybolt L. 980
5 Flange ø 50/87
6 Stub
7 Thrust bearing
8 Nut
9 Tightening wrench
1
6
12
3
4
Fig. 7
1
9
Fig. 8
45