Maintenance; Troubleshooting Support; Technical Data; Identification Plate - DURAVIT Jet Project Manual De Instrucciones

8. Maintenance

Residual-current circuit-breaker
Check the residual current circuit breaker (RCD) regularly as described in its operating
instructions.

9. Troubleshooting Support

CAUTION
The whirltub may be repaired only by a qualified plumber and/or
electrician.
Problem
Foaming
Whirltub system runs only
briefly.
Whirltub system does not
start.

10. Technical Data

10.1 Identification Plate
The identification plate is on the back page of the operating instructions or in the tech-
nical area of the whirltub.
This product conforms to all the appropriate EU guidelines.
DIN EN 12764, DIN EN 60335-2-60, IEC 60335-2-60
Potential cause
Soap or shampoo in the bath-
water.
Water level too low.
Mains switch is switched off.
Mains fuse is switched off.
Ground-fault switch (RCD) or
circuit breaker has tripped.
Solution
>
Switch off the whirltub
system.
>
Fill the tub with fresh water.
>
Add water until the water
level is about 5 cm above the
uppermost jet.
>
Press the "Jet" button for a
while.
>
Switch on at the mains.
>
Switch on the mains circuit
breaker.
>
Disconnect the tub from the
mains.
>
Call customer service.
21