Installation - Belkin F5U217ea Manual De Usuario

P74081ea-F5U217ea-8-02.qxd
1. Plug the AC adapter into a wall outlet or surge suppressor.
Plug the DC connector into the DC power jack found on the
side of the Hub.
Note: The Hub may be used without the power supply when
connecting low-power devices such as keyboards and mice.
Remove the USB A cable connector from its built-in storage
bay, then plug it into the downstream port of your computer, or
downstream port of another hub (see Fig. 1).
Upstream Port
Figure 1
Important Note: The Hub must be connected to a USB
2.0-compliant host in order to function in high-speed mode
(480Mbps data rate). If the Hub is connected to a USB
1.1-compliant host, it will operate only in low-speed or
full-speed mode (1.5Mbps/12Mbps).
2. Your Windows operating system will now detect your
Hub and install the required driver support. (The Windows
8/28/02 5:47 PM

INSTALLATION

Port 1
Port 2
4
Page 4
Port 3