Troubleshooting; Technical Data - Topcom BUTLER S100 Manual De Usuario

Topcom Butler S100
6.4 Setting the speaker ON/OFF
If you only want to use the blinking LED (visual indicator) and not the speaker, turn the
speaker switch to the left;
6.5 Setting the ring tone
Press the tone button
will be stored automatically until you press the tone button

7 Troubleshooting

Problem
Green LED blinking
Ringer volume too low or no
ring sound
Cannot register

8 Technical Data

Range (base depending):
Batteries:
Max. standby time:
Ring sound:
Ambient temperature:
Permitted relative air humidity:
Power supply adapter:
6
= OFF.
repeatedly until the desired ring tone is heard (1-9). The ring tone
Possible cause
Out of range
Not registered
Selected ring tone not
ideal
Speaker switched OFF
Base has no free
handset anymore
Base system pin is not
'0000' or '1111'
Base is not in
registration mode
up to 300 m in open space
up to 50 m in buildings
3 x 1.2V, 2200 mAh AA Type NiMH rechargeable
approx. 400 hours
85dBA max.
+5 °C to +45 °C
25 to 85 %
220/230V, 50 Hz
6VDC 300mA
again.
Solution
Put the unit closer to the base
Make sure the unit is registered
on a DECT base
Adjust the ringer tone, some
tones are clearly hearable then
others, the volume cannot be set!
Make sure the speaker switch is
turned ON
Remove one registered handset
from the base
Make sure the system pin of your
base is set to '0000' or '1111'
See you base/telephone manual
how to put it into registration
mode
Topcom Butler S100