Tabla de contenido
Publicidad
recommended when using the stroller in parent-facing
mode, i.e. when the child is still rather small.
37. Slide the shoulder pads onto the straps as seen in dia-
gram 37 G.
38. Slide the crotch strap into the relative opening (dia-
gram 38 A) and the lap belt buckle into the side slots
(diagram 38 B)
WARNING: use the clasps to adjust the width of the lap
belt as necessary.
WARNING: the safety harness must always be fastened to
guarantee complete safety for your child.
TRANSFORMABLE HOOD
39. The seat has two fixtures on the sides of the seat base
which can be used to fit the hood. To assemble the hood,
insert the hook-on system into the fixtures, as seen in
diagram 39. As the hood is connected to the seat, you
don't need to turn it around when you switch between
the front-facing and parent-facing modes.
40. To open the hood, press the front arch forwards and
fasten it in place using the side compasses as seen in dia-
gram 40.
41. The hood has an extractible mesh feature to help protect
your baby from excessive sunlight.
42. Open the side zips (diagram 42) to remove the rear flap
and turn the hood into a summer sun-hood.
43. To remove the hood, take hold of it near the connector
fixtures and simply pull it upwards, sliding the fasteners
upwards (diagram 43).
WARNING: The hood must be fitted correctly on both sides
of the stroller. Check that it is securely fastened.
FULL-COVER RAIN HOOD
A rain cover can also be fitted onto the stroller.
44. Fasten the rain cover in place threading the buttons into
the slots on the sides of the hood, as seen in diagram 44.
When you have finished using it, allow it to dry properly
(if it is wet) before you fold it away. The rain cover can be
used in either parent-facing or front-facing mode.
WARNING: Use only the raincover supplied or approved
by the manufacturer.
WARNING: Do not use the rain cover if the stroller is not
fitted with the hood or sun canopy to prevent the risk of
suffocation.
To prevent the risk of overheating or suffocation, never leave
the stroller under the sun with the rain cover fitted to it.
LEG COVER
45. To fit the leg cover, fasten the snap-button, found on
the back of the leg cover, to the lower section of the seat
leg rest (diag. 45).
The leg cover can be used in two different modes (section
46 and 47).
46. Thread the top part of the leg cover under the bumper
bar and fasten in the highest position inserting the buttons
into the slots on the side wings of the seat (diagram 44 B).
47. The leg cover can be folded back over the bumper bar
and buttoned in place using the slots, as seen in diagram 47.
ITEM BASKET
The stroller comes with a practical item basket.
48. To fit the basket onto the stroller, connect the clasps
A on the basket to the two hooks on the front section of
the stroller, and connect the 4 rings to the relative hooks
B (diagram 48).
WARNING: Do not overload the basket with weights of
over 5 kg. You must remove all contents from the basket
before you close it.
BAG
Some versions of the stroller come with a practical carry-all
bag, which includes a changing mat.
49. Fit the bag onto the stroller as seen in diagram 49.
50. The bag can be used in two different ways. Option 1
(medium size): Clip the shoulder strap clasps to the rings
on the sides, as seen in diagram 50A, and fold back the flap.
Option 2 (large size): Clip the shoulder strap clasps to the
rings on the end, as seen in diagram 50B.
WARNING: do not overload the bag with weights of over
2 kg.
WARNING: exceeding the above indicated limit, with the
bag attached to the handles, may compromise the stability
of the stroller and cause it to topple over.
Important note: the images and instructions contained in
this handbook refer to one version of the stroller; some
components and functions described herein may vary ac-
cording to the version of the stroller you have purchased.
FOR UK MARKET ONLY: COMPLY TO BS 7409
WARNING: A CHILD'S SAFETY IS YOUR RE-
SPONSIBILITY.
Children should be harnessed in at all times
and should never be left unattended. The child
should be clear of moving parts while mak-
ing adjustments. This vehicle requires regular
maintenance by the user. Overloading, incorrect
folding and the use of non-approved accessories
may damage or break this vehicle.
WARNING: When used as a pram body, remember that:
• The depth of the pram body measured from the top of
the mattress to the top of the side of the body at, or at
any position within 300mm from, the harness attachment
points, should not be reduced to less than 140mm when
the mattress is in position;
• The matress purchased separately should conform to
BS 1877 : Part 10.
• SAFETY HARNESS – For extra safety the stroller is fitted
with "D" rings, which can be used to fit a separate safety
harness, compliant with BS 6684 standards.
The rings are positioned inside the seat of the stroller on
the left and right sides as shown in fig. 16.WARNING: when
using this product in the car, use the lap belt assembled on
the carrycot frame only.
25
Publicidad
Tabla de contenido
