Festool OF 1400 EQ Manual De Instrucciones página 4

4
connected and properly used. Use of these devices can
reduce dust related hazards.
4) Tool use and care
a) Do not force the power tool. Use the correct power
tool for your application. The correct power tool will do
the job better and safer at the rate for which it was designed.
b) Do not use the power tool if the switch does not
turn it on and off. Any power tool that cannot be controlled
with the switch is dangerous and must be repaired.
c) Disconnect the plug from the power source before
making any adjustments, changing accessories, or
storing power tools. Such preventive safety measures
reduce the risk of starting the power tool accidentally.
d) Store idle power tools out of the reach of children
and do not allow persons unfamiliar with the power
tool or these instructions to operate the power tool.
Power tools are dangerous in the hands of untrained users.
e) Maintain power tools. Check for misalignment or
binding of moving parts, breakage of parts and any
other condition that may affect the power tools
operation. If damaged, have the power tool repaired
before use. Many accidents are caused by poorly maintained
power tools.
f) Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting edges are less
likely to bind and are easier to control.
g) Use the power tool, accessories and tool bits etc., in
accordance with these instructions and in the manner
intended for the particular type of power tool, taking
into account the working conditions and the work to
be performed. Use of the power tool for operations different
from those intended could result in a hazardous situation.
5) Service
a) Have your power tool serviced by a qualified repair
person using only identical replacement parts. This will
ensure that the safety of the power tool is maintained.
SPECIFIC SAFETY RULE FOR ROUTERS
a) Hold power tools by insulated gripping surfaces
when performing an operation where the cutting tool
may contact hidden wiring or its own cord. Contact with
a "live" wire will make exposed metal parts of the tool "live"
and shock the operator.
b) Use clamps or another suitable means to support
and secure the workpiece to a stable platform. Holding
the workpiece by hand or against your body is unstable and
may lead to loss of control.
TO REDUCE THE RISK OF INJURY,
USER MUST READ AND UNDERSTAND
INSTRUCTION MANUAL.